View Single Post
Old 11-28-2012, 11:50 AM   #659
MRF582
Scooby Guru
 
Member#: 48219
Join Date: Nov 2003
Chapter/Region: MAIC
Location: Pittsburgh, PA
Vehicle:
. Always drive
the race line .

Default

Quote:
Originally Posted by yamahaSHO View Post
Since you know the above, 100% WGDC should be FULL MBC control (closes off EBCS forcing pressure through MBC ONLY). With the EBCS going to the inlet, you cannot have FULL MBC control as your boost pressure will find its way into the inlet vs pushing the ball and spring.
That's a good point. I wonder why I haven't experienced overboosting issues with running it back to the inlet.

But yes, you're right, capping it off and effectively making it a restrictor style 2-port should be the best way.

But here's a question. Does this slight 'overboost' which introduces more pressure pre-compressor, maintain the same pressure ratio across the compressor? So this overboost, simply allows for more air to flow through without making the efficiency any worse?
* Registered users of the site do not see these ads.
MRF582 is offline   Reply With Quote