View Single Post
Old 12-01-2012, 12:05 PM   #3
CSibbs
Scooby Specialist
 
Member#: 262532
Join Date: Oct 2010
Chapter/Region: Tri-State
Location: Long Beach Island
Vehicle:
'12 STI
DGM

Default

does the expansion tank contain the lines that run into the turbo? I was just thinking about putting a regular bolt in the banjo bolt fitting on the back of the motor, but was concerned about it causing too much pressure.
Do you think I could just re route it somehow?
* Registered users of the site do not see these ads.
CSibbs is offline   Reply With Quote