View Single Post
Old 12-01-2012, 01:13 PM   #285
baseballdbk1
Scooby Specialist
 
Member#: 242700
Join Date: Mar 2010
Chapter/Region: Tri-State
Location: Pittsburgh, Pa
Vehicle:
2011 Impreza Wrx Sti
White

Default

Quote:
Originally Posted by Layvon View Post
How did you run the lines through the cabin? ( Mainly where did you go through firewall at? )

Looks good!
Thanks man!

I ran them through the firewall in the same location as the stock lines and even used the factory rubber grommet by just making the holes a lil bit bigger and fit like a charm with no chance of rubbing against metal

EDITED: The -8 & -6 Russell Pro Classic lines fit in the exact same spot as the stock lines did running them through the cabin area under the hard plastic shielding on the driver side as you can see in the previous post pictures from when I was removing the stock lines! I thought fitment was going to be an initial issue but after test fitment, everything fits perfectly with no sign of crimping throughout the routing
* Registered users of the site do not see these ads.
baseballdbk1 is offline   Reply With Quote