View Single Post
Old 12-02-2012, 09:38 AM   #2
Vlad
Scooby Guru
 
Member#: 46135
Join Date: Oct 2003
Chapter/Region: Tri-State
Location: NY
Vehicle:
02 WRX
Sti V9 Spec C

Default

The JDM main engine wiring goes into the firewall on the opposite side, the right side.
If this is where your harness stops, you won't be able to do much with it.

If this is not where it stops, you still won't be able yo do much with it, as it locates the cluster on the opposite side, the same goes about the ECU, etc.

You're best off finding a cheap WRX harness and merging with that, namely, plug the engine harness at the main connectors into the WRX harness and use that, together with an available free WRX wiring harness diagram, to complete your swap.
* Registered users of the site do not see these ads.
Vlad is offline   Reply With Quote