View Single Post
Old 12-04-2012, 01:16 PM   #10
Trustkevin13
Scooby Specialist
 
Member#: 259184
Join Date: Sep 2010
Chapter/Region: MWSOC
Location: Kansas
Vehicle:
2008 Subaru WRX
Silver

Default

Quote:
Originally Posted by cianuro View Post
I just bought a muffler and center pipe from the STi to do the same... So a question...

The muffler tips look like they hang too low from the bumper. Would it be possible to bend the hanging rods a bit to avoid this? Did you try anything, or did you just install it as it fell in place?

As for the bumper... How did you measure the cuts? Did you remove the bumper? I'm trying to decide whether I should remove the bumper or not. My guess is I would do a better job by removing it, although it'll be a lot easier to leave it on.

Mine's silver also, so your pic just gave me an actual idea of how it'll look on my car. I don't like how low the tips look, so I might have to work around that, but I'll probably replace the tips with bigger ones to better fill the gap...
Top to bottom. - They do hang pretty low, i just noticed that. I Just put it on and bam! it fitted cause the hangers are the same for the hatches. I believe you could bend it but i'd question the strength of it. if you could safely do it, you could. -I basically cut off the rectangle of the left side up to the top and to the first divider next to it (right). I did it with it on and a very steady hand and good saw. - the tips are a bit small but you could just buy any sti or 11wrx+ exhaust cause they would all work, i just happen to get mine really cheap and i prefer a quiet car so i got the stock one.

check the link out for some more pics, theyre not recent cause i have a sti spoiler and black emblems now. http://forums.nasioc.com/forums/show....php?t=2399047
* Registered users of the site do not see these ads.
Trustkevin13 is offline   Reply With Quote