View Single Post
Old 12-04-2012, 10:15 PM   #185
KillerBMotorsport
NASIOC Vendor
 
Member#: 198281
Join Date: Dec 2008
Chapter/Region: MAIC
Location: Virginia
Vehicle:
2005 WRX/STi
WRB of course

Default

Most just thread the NPT sensor into the BSPT port. The thread diameter and pitch is so close that once the thread sealant is applied it seals just fine.

Many will argue that this is a bad and in any other situation I'd never recommend using the wrong threaded anything, but in this case, it's common and acceptable because it works just fine.
* Registered users of the site do not see these ads.
KillerBMotorsport is offline   Reply With Quote