View Single Post
Old 12-06-2012, 06:56 PM   #7
APM Tuned
NASIOC Vendor
 
Member#: 282460
Join Date: May 2011
Chapter/Region: MWSOC
Location: Villa Park, IL
Vehicle:
2005 Evo-STI
R.R.-WRB

Default

okay, simply put...do you have pigtails? If not, why not source some pg tails to help the install be easier than chopping up the harness, extending some wiring and doing a "hard solder".

If you have the pig tails, and you have the wiring setup, do you require finding the pin outs or diagram and soldering into that with the new DCCD controller on the WRX?

Two different things going on there. No controller with ready wiring, no controller and wiring required.

I'm only asking as to the extent of the work is all.

-Mark
* Registered users of the site do not see these ads.
APM Tuned is offline   Reply With Quote