View Single Post
Old 12-13-2012, 09:07 PM   #6
rushdylan
Scooby Specialist
 
Member#: 337170
Join Date: Nov 2012
Location: hesperia, California
Vehicle:
2003 wrx
silver

Default

Quote:
Originally Posted by motoman399 View Post
nice. it looks good. i ported and polished my td04 also. i think i went larger on the turbine inlet though. i made mine 2" roughly and i didnt touch the outlet, i didnt see the outlet netting much results. also have my compressor side ported and polished. i noticed good results. but i also did an up pipe at the same time.

out of curiosity, what bits are you using to port and polish with?
I'm debatin if I will go larger on turbo inlet. maybe I will leave the outlet alone because it wouldn't make sense if the air came from the smaller intake housing into a big ass port. it would let it expand and basically lose pressure in turn. although it might not register on a gauge. I have this whole kit I bought from summit racing. it uses a little rod that goes into my 1/4" die grinder and the sanding tips thread onto the rod which tapers at the top. I polish first with a blue sponge type deal and finish with a softer red one. I've had the ports on my 250 looking exactly like a mirror and by that, I mean I could see my eye lashes in the reflection! carbon simply wipes right off of it
* Registered users of the site do not see these ads.
rushdylan is offline   Reply With Quote