View Single Post
Old 12-14-2012, 09:57 PM   #436
2slofouru
NASIOC Supporter
 
Member#: 90539
Join Date: Jul 2005
Chapter/Region: South East
Location: somewhere east of CA
Vehicle:
95 L with ej257k
powa, Raven R6

Default

So its a combination of not enough demand and you knowing the program would not work without signifigant modification. Fair enough and thanks for the reply.

I found a shop that says their cnc program will also work with the clover heads I will take before and after pics if all goes well, if you're curious.



Quote:
Originally Posted by Equilibrium Tuning View Post
I'm sorry you were not satisfied with my response, but I think it was very clear and honest. I've never attempted this on the clover style chambers and know that the current program would likely not work without significant modification. I've had maybe 2-3 requests for clover style heads over the last few years so its not really worth the time investment to develop a new program. I would also need a pair of test heads which is another expense. It's just not something that we looked into much at all because there is not a lot of demand for it. As stated, there are other vendors who can do something similar by hand for you so that's probably your best bet.

Hopefully that answer satisfies your inquiry better.

Thanks
-- Ed
* Registered users of the site do not see these ads.
2slofouru is offline   Reply With Quote