Thread: Teh XXR thread!
View Single Post
Old 12-21-2012, 04:40 PM   #5507
skatin707
Scooby Specialist
 
Member#: 251552
Join Date: Jul 2010
Chapter/Region: HIIC
Location: Honolulu, HI
Vehicle:
2014 FXT
Satin White Pearl

Default

Quote:
Originally Posted by cuztomimportz View Post
There is a thread on here I think from JNA out of Long Island NY. For $50 plus a refundable deposit they will ship you the roller anywhere and you can do it your self. Get or borrow a cheap heat gun so you don't crack the paint. And those over fenders should just pop off. I put the oem over fenders in my bug and after drilling the holes they just snap on. Just get yourself some new 3m tape to replace the old when you take them off (that is if you even have to take them off. You aren't rolling that much of then fender anyways.
I'll look into that.

Quote:
Originally Posted by DJ_RamBam View Post
Okay so I need some thoughts:

XXR is coming out with the 530 in 19x10.75 +20

Would this even fit a GR STI on BC BR Coils?? I am assuming the answer is no, unless i had crazy camber set up with new control arms. (fenders are rolled)
Stock wheel size is 18x8.5 +55. The difference in offset is 35mm (1.38"). Adding the wheel differences (width) gives you 3.63", or 1.815" wider on each side.

I'm going on a (short) limb here, but I'm guessing no. +20 is too far out to push a wheel that size.
* Registered users of the site do not see these ads.
skatin707 is offline   Reply With Quote