View Single Post
Old 12-26-2012, 03:56 PM   #248
MattTHEpainter
Scooby Specialist
 
Member#: 284046
Join Date: May 2011
Chapter/Region: NESIC
Location: CT
Vehicle:
2000 Impreza w/ WRX

Default

Quote:
Originally Posted by Caustin
Hey Matt. My family got me a set of startingline paint guns for christmas as I've been talking about painting my car for a while now. The requirements say that it needs 13 cfm with a 10psi cap with 30 psi inlet. Now, I don't have an air compressor anywhere near big enough for this job and I was looking to rent an air compressor. I found a gas powered one near me, 8hp and 17 gallon tank with 16cfm. Would this work for me? Or do you have any recommendations?
Thank you, Connor
Hey Connor. That's awesome that your family supports you. The one you found for rent should work just fine. The more CFM the better. You don't want the gun spiking or dropping pressure on you. Investing in a pre gun regulator/ water separator would be a smart move too.

Make sure you document your progress and ask any questions you have.
* Registered users of the site do not see these ads.
MattTHEpainter is offline   Reply With Quote