View Single Post
Old 01-06-2013, 04:12 AM   #101
Kyle_J
Scooby Newbie
 
Member#: 292364
Join Date: Aug 2011
Chapter/Region: MWSOC
Location: Neeebraska
Vehicle:
2004 STi
WRB

Default

Quote:
Originally Posted by spoolinsti05 View Post
Hey you used my battery hook trick

That's ****ty man Look's like an oiling issue from the rod. How's the rod bearings look on the cylinders with the scored pin's?

Do you know bearing clearance? Who built this engine? Was oil pump packed for start up? Look's like it happened on start up.

BUT WHAT DO I KNOW LOL
I haven't split the block yet, just pulled those two pistons. I built the block, bearing clearances were good when assembling. I did not pack the oil pump but used lots of redline assembly lube and fully primed the motor before starting
* Registered users of the site do not see these ads.
Kyle_J is offline   Reply With Quote