View Single Post
Old 01-08-2013, 01:12 AM   #22
scootarida1
Scooby Newbie
 
Member#: 154534
Join Date: Jul 2007
Chapter/Region: Tri-State
Location: Wilkes-Barre, PA
Vehicle:
2005 Forester XT
Borg Warner S261

Default

So I am going to be balancing the rods in the next couple of days. I figure I'll balance the big ends and then do the small ends.

Where is everyone removing material on the big ends? The only area that seems feasible is around the sides by the bolts and just following the contour on a belt sander.
* Registered users of the site do not see these ads.
scootarida1 is offline   Reply With Quote