View Single Post
Old 01-08-2013, 11:15 PM   #67
aod12
Scooby Specialist
 
Member#: 282701
Join Date: May 2011
Chapter/Region: Tri-State
Location: New York
Vehicle:
2008 FXT
WRB

Default

Quote:
Originally Posted by raabguy View Post
Ok so im getting a little frustrated, apparently the ball bearing was inside the grease fitting cause i guess i unscrewed the grease fitting in half. Now this nut is stuck on the end of the hose..

This is supposed to come off right? I have been trying to get it off with 2 wrenches and it will not budge, my dad wasnt able to get it apart either. wtf, has anyone else had this problem??
Bump because I had this problem. Lightly, very lightly heat it up then go at it with the wrenches again
* Registered users of the site do not see these ads.
aod12 is offline   Reply With Quote