View Single Post
Old 01-09-2013, 10:36 AM   #56
luan87us
Scooby Specialist
 
Member#: 335013
Join Date: Oct 2012
Chapter/Region: RMIC
Location: SL,UT
Vehicle:
2013 Premium WRX 5dr
WRB

Default

Quote:
Originally Posted by PearlRex11 View Post
I didn't have to cut any zip tie when unplugging the 02 sensor. I just pushed out the little plastic pin that had a zip tie built into it and when I was done I plugged it back in again. I think it was right next to one of the dp bolts. I'm fine with keeping the spt shifter, can't imagine the material would make any difference, thanks to xluben's pictures/measurements he took I didn't buy the kartboy. Thanks xluben, saved me some money!
A set of Front & Rear Kartboy shifter bushings are coming in the mail for me tomorrow. Hopefully it won't take too much effort for me to get them installed. Did you have to remove the tranny cross member? I don't have anything to support the trann will that be a problem to remove the cross member?
* Registered users of the site do not see these ads.
luan87us is offline   Reply With Quote