View Single Post
Old 01-09-2013, 08:47 PM   #59
PearlRex11
Scooby Specialist
 
Member#: 284420
Join Date: Jun 2011
Chapter/Region: SWIC
Location: Lakewood, Ca
Vehicle:
2011 WRX Sedan
SWP

Default

Quote:
Originally Posted by luan87us View Post

A set of Front & Rear Kartboy shifter bushings are coming in the mail for me tomorrow. Hopefully it won't take too much effort for me to get them installed. Did you have to remove the tranny cross member? I don't have anything to support the trann will that be a problem to remove the cross member?
Definitely do it man, once you start on it you will see that it's not too bad. Really take your time with the rear one so you don't cross thread it like others have said. I suggest threading the new bolt in without the bushing first, so you can see the angle it needs to go in at. When I did that it went in right away. also remember the rear kb bushing has the holes slightly closer together than they should be, you will have to start one (preferably the passenger side one) first and then get the bushing to flex slightly to get the other bolt to start, also leave the first bolt only threaded in about halfway before you do that. It really isn't too bad though.
* Registered users of the site do not see these ads.
PearlRex11 is offline   Reply With Quote