View Single Post
Old 01-10-2013, 10:15 AM   #70
foolycooly
Scooby Specialist
 
Member#: 260545
Join Date: Oct 2010
Chapter/Region: MAIC
Vehicle:
2011 WRX Limited 4dr
WRB

Default

I'm going to install this shifter and bushings in my 4-door this weekend. 2 questions:

1. Would putting the front wheels on a set of ramps leave me adequate room underneath to get the bar out/bushings in?

2. Would it be a good idea to put some non-permanent loctite on the pivot bolt since the torque specs are so low? And would there be an easy way to approximate the appropriate torque on this bolt without a torque wrench?

Thanks.
* Registered users of the site do not see these ads.
foolycooly is offline   Reply With Quote