View Single Post
Old 01-15-2013, 10:45 PM   #83
gsrcrxsi
Scooby Specialist
 
Member#: 236952
Join Date: Jan 2010
Chapter/Region: MAIC
Location: Baltimore
Vehicle:
2010 WRX (SSM)
Stg "2+" 300hp/360trq

Default

Quote:
Originally Posted by KNS Brakes View Post
Bracket bolts on an older knuckle just fine (press in bearing)

I raised the points a bit too much so the pad sits high - that's an easy fix.

But...
I was looking at a newer knuckle w/ bolt in bearing assemblies. At least on an STi knuckle it will not fit (at all)

Who has a pic of a bolt in new age knuckle? That will require a different bracket I bet.
Well the STi does have a larger bearing than the WRX does. So maybe that's just the hang up.
* Registered users of the site do not see these ads.
gsrcrxsi is offline   Reply With Quote