View Single Post
Old 01-22-2013, 09:59 PM   #25
Layvon
NASIOC Supporter
 
Member#: 195711
Join Date: Nov 2008
Chapter/Region: MWSOC
Location: Cadillac MI
Vehicle:
STi 04/05/06/07
JBP / OBP for now

Default

Quote:
Originally Posted by Coop1103 View Post
I will be using Cobb Engine Mgmt. Looking in to if I can run speed density with the Cobb for this. As for sleeving it basically came down to cost. It was an additional $1200 to sleeve it so I passed. I did not come across enough proof that the was the sure way to go for preventitive measures on the newly built engine.
You will have no issue doing speed density with the Access Port. I wouldn't even piddle around with MAF based tuning on a build like this, except for break in if going e-tune. I wish I would have done some sort of reinforcement on my block, if it pops after two summers vs three I saved 50% on the build. But i didn't so who knows.
Levon
* Registered users of the site do not see these ads.
Layvon is online now   Reply With Quote