View Single Post
Old 01-29-2013, 02:16 AM   #14
949
Scooby Specialist
 
Member#: 58906
Join Date: Apr 2004
Default

Quote:
Originally Posted by jonow6 View Post
I would assume that red screw seat you are talking about would be manufactured for their specific application. They all look to be turned out of aluminum and anodized red. Personally I don't think it is a necessity unless your screw is not perpendicular to the brake cylinders surface, in which case it will be a lot of pressure on an extremely small surface area.

Will you be doing up the design for them, or will the shop be measuring it up?
it would be a combined effort.
* Registered users of the site do not see these ads.
949 is offline   Reply With Quote