View Single Post
Old 01-30-2013, 05:47 PM   #19
danny_d19
Scooby Specialist
 
Member#: 180748
Join Date: May 2008
Chapter/Region: VIC
Location: BC
Vehicle:
2005 STi
CGM

Default

Quote:
Originally Posted by Rally STi Guy View Post
Danny in the pictures that you posted is there a joint or "mold line" on the back half of the new ones or just the picture?
There's a joint, a rather weird one. The outer "flared" part of the skirts and all the rest are all one piece, but the flat part at each end where you see that joint is another piece joined in and riveted. You can see one rivet at the end (bottom of pic) and one at the joint line. I can take closer pics tonight.

And I emailed the seller on ebay just to make sure the point of the holes and screws is to screw into the factory skirts and was correct:

"Briefly to install this side skirts you need to use your OEM Black clips under your car i believe theirs 6 of them on each side. you mount the side skirts with your OEM clips to hold the side skirt up in place then we also provide about 18 screws. you will see the holes on the lip already done. ones your side skirt its in place with the clips you can just pre-drill the screws in to the pre-drill holes on the side skirts."
* Registered users of the site do not see these ads.
danny_d19 is offline   Reply With Quote