View Single Post
Old 02-12-2013, 06:14 PM   #27
manitou
Scooby Specialist
 
Member#: 193757
Join Date: Nov 2008
Chapter/Region: MWSOC
Location: Cedar, MI HP Techs MPS-SSLR2.5
Vehicle:
2006 XTI Limited
OBP, Junior tuned 573WHP

Default

Quote:
Originally Posted by BlazeRex View Post
I'm soo confused as to what you're getting to. Bumping base pressure?
OK, I'll spell it out in more detail.

A bigger pump (like the walbro 465) with a larger 10-12 gauge re-wire through the OEM FPC will help maintain a constant voltage at the 33, 66 and 100% pump duties, a FPR (like the Aeromotive 1000) to set the base pressure higher like 50 psi and you can increase the flow rate of any injector. If you do this you can decrease the IDC's for the given injector.

Now improve VE by means like the Killer B Holy Header and head work, PnP of the intake manifold, piston design...etc....and then you will make more power at lower rpm's and make more over all because you are wasting less power through parasitic loss!

You make more with less! Less is more Capish?
* Registered users of the site do not see these ads.
manitou is offline   Reply With Quote