View Single Post
Old 02-14-2013, 04:06 PM   #5
Aaron'z 2.5RS
Scooby Guru
 
Member#: 1026
Join Date: Mar 2000
Chapter/Region: MWSOC
Location: Hickigan
Vehicle:
'00 RS/WRX Stg5
'98 RS Stock

Default

Quote:
Originally Posted by rick-l View Post

Are those blocks with a groove that make contact with the channel on each side of the pinch weld?
Outrigget plates are somewhat triangle shaped and connects the rear diff outrigger bushings to the rocker panels..

Hard to miss if you look..

To be honest, its easier to pull the motor IMHO, ive done it both ways and getting the trans OUT is easy, getting it back not so much, especially when your arms are going numb from no blood and you haven't got the sucker to slide in yet...

Motor hanging off a hoist makes life a lot easier
* Registered users of the site do not see these ads.
Aaron'z 2.5RS is offline   Reply With Quote