Originally Posted by kinger37
I'll try to get some pictures up tomorrow. I went with the original and I really like the way they look.
As for the instillation, the rear mudflaps bolt right into the holes pre drilled into the mudflaps. When I installed them I didn't use the mounting hardware that clips to the fender that they came with, rather a nut a bolt and a washer. When I installed the front flaps you remove the bolt from the Aero guards and that bolts up perfectly for one of them. The next bolt you have to get creative. The upper bolt I believe is required to go through the fender liner. What I did was cut a very thin slit through the fender liner so I could get the nut behind the fender liner(you can't even see the cut in the fender liner). Once I had this cut I taped a nut to a wrench and carefully put it through the slit and lined it up with the hole through the fender. Then I threaded the bolt through.
Again I apologize if this is really confusing. I'll do my best to help get some pictures tomorrow to help explain haha
Thanks, I think the pictures would help tons.