View Single Post
Old 02-18-2013, 09:32 AM   #9
Wicked Innovation
NASIOC Vendor
 
Member#: 265606
Join Date: Nov 2010
Location: Manchester, NH
Default

The bolt tends to seize into the bushing sleeves, you can sometimes get the front one loose and then remove the rear lateral link with the bolt. What I do that usually works well is to loosen the nut and then thread it on the bolt so the bolt comes just to the end (not tight). Air hammer the bolt toward the rear of the car until the front bushing sleeve is free of the bolt. Now put the nut back on and tighten the bolt back down. Using a long (3' or more) bar, overtighten the head of the bolt so that it snaps off. It's surprisingly easy to do considering it's M14. With the head off, you can hammer the bolt forward to free it from the rear bushing sleeve. If you can't get it free from the rear link, just remove the link and either replace it or press the remainder of the bolt out of the sleeve.
* Registered users of the site do not see these ads.
Wicked Innovation is offline   Reply With Quote