View Single Post
Old 02-25-2013, 08:31 PM   #3
jarrodblake
Scooby Newbie
 
Member#: 314134
Join Date: Mar 2012
Location: patriot IN
Vehicle:
02 wrx
midnight black

Default

Quote:
Originally Posted by txl146 View Post
Do you have all the right tools to remove ball joint from the knuckle? If I were you, I will try to find OEM ball joint from FS section. That's where I found 2 new ball joints for $25 shipped. I'd recommend either OEM or Moog for tie-rod.

Yes I have all the tools. I had forgotten about moog I used them on a few other car, I may use them.

I am having the same issue, but it wasn't the ball joint or tie rod end. Next thing I'm going to replace is axle and putting in a spacer between bar and end link.
This is what I'm trying to avoid, not that they couldn't use to be replaced, but I don't want to spend the money on something that wont fix the problem. As for the axle mine look new and the boots are in great condition, However I will see if I can get them to make noise when I look at the car tomorrow.
* Registered users of the site do not see these ads.
jarrodblake is offline   Reply With Quote