View Single Post
Old 03-05-2013, 11:53 PM   #11
Bugzy22
Scooby Newbie
 
Member#: 335716
Join Date: Oct 2012
Chapter/Region: NWIC
Location: Renton, wa
Vehicle:
2001 2.5rs
White

Default

Quote:
Originally Posted by FLUBYUx2 View Post
Hey, please please please try to document the dash swap and gd dash harness work. I can't, for the life of me, find any concrete info on what needs to happen to make the gd wirin plug into the Rs chassis. If the gd harness can be unpinned and have the Rs connectors inserted so it plugs into the Rs vehicle harness, ill be quite happy. I much prefer swapping pins/connectors over cutting and soldering.

I'm also wanting to see what you do for the dash beam. I'm hoping to see a good way of doing it rather than the easy way.
Im planning on swapping the gd dash into the gc as well if that is what you are inquiring about. There should be little wiring work needed. I am sending the harness off to Chase Bays for a mil-spec and tucked harness. Keep posted, as this is far from being close to that point yet.
* Registered users of the site do not see these ads.
Bugzy22 is offline   Reply With Quote