View Single Post
Old 03-06-2013, 07:12 PM   #1
mopar3.0
Scooby Newbie
 
Member#: 261696
Join Date: Oct 2010
Chapter/Region: E. Canada
Vehicle:
2004 wrx
red

Default Shifter linkage bearings ,my experiment

Measured the busings from my sti and found these bearings on e bay.
At a cost of 8 dollars i wanted to try some cheap ones before sourcing out some quality pieces,

The shifter its self will have to be drilled out to fit the beaings, it appears to be about 1mm too small.

Any one every try anything like this?,debating on maby adding some grease nipples to the housing too.
car is still in pieces and snow is still on the ground so won't be any testing for couple months.
* Registered users of the site do not see these ads.

Last edited by mopar3.0; 03-06-2013 at 07:19 PM.
mopar3.0 is offline   Reply With Quote