View Single Post
Old 03-08-2013, 06:19 AM   #7
mopar3.0
Scooby Newbie
 
Member#: 261696
Join Date: Oct 2010
Chapter/Region: E. Canada
Vehicle:
2004 wrx
red

Default

they do fit, needs small washers on both side on out side, gona use copper crush washers ,

if not the fork will bind up on the out side part of the bearing when you thighten it down

Im also thinking about a spacer between the 2 bearings so you dont side load the bearings when you also tighten it down
(just trim the sleve from the old bushing set up)
* Registered users of the site do not see these ads.
mopar3.0 is offline   Reply With Quote