View Single Post
Old 03-10-2013, 04:46 AM   #8
Uncle Scotty
Scooby Guru
 
Member#: 16200
Join Date: Mar 2002
Vehicle:
OK Houston
we have an Uncle

Default

Quote:
Originally Posted by mopar3.0 View Post
they do fit, needs small washers on both side on out side, gona use copper crush washers ,

if not the fork will bind up on the out side part of the bearing when you thighten it down

Im also thinking about a spacer between the 2 bearings so you dont side load the bearings when you also tighten it down
(just trim the sleve from the old bushing set up)
keep us posted on this and what ya do to make it work
* Registered users of the site do not see these ads.
Uncle Scotty is offline   Reply With Quote