View Single Post
Old 03-29-2013, 04:55 PM   #147
kvo01
Scooby Newbie
 
Member#: 345187
Join Date: Jan 2013
Chapter/Region: MWSOC
Location: Des Moines, IA
Vehicle:
2003 WRX Wagon
Silver

Default

Quote:
Originally Posted by satrya View Post
Opening and making sure the butyl rubber goo doesn't stick onto the headlight lens etc. is important. Otherwise, cleanup is quite challenging.

I highly recommend retrofitting a different set than your oem. If price is a constraint:
  • Consider a replica oem headlight set or someone's oem headlight posted in the classifieds
  • Consider HID bulbs from TRS instead of regular Phillips, Osram, or more expensive alternatives. You can always "upgrade" to better bulbs later. But don't completely skimp and buy no name HID bulbs either.
  • Wait for group buys or garage sales from your favorite vendor. TRS just had a garage sale that offerred 2nd hand Ma-tsu-shi-ta ballasts for a lower price than their aftermarket ballasts. TRS' ballasts offer good value. I wouldn't consider any other aftermarket options that are less expensive.
  • Take your time before deciding which projectors to get. I chose Mini D2S for my first retrofit because I wasn't sure if anything bigger could fit. While I was satisfied with the output relative to the oem halogen reflectors, I later found out that I had ample space in my aftermarket headlights to fit a bigger unit. So I ended up spending money on 2 sets of retrofit systems.
  • Check the beam alignment on the car before resealing the headlights. I've seen too many eager retrofitters in HIDP forum that sealed the headlights back, mounted them back on the car, and found that the alignment was off.
The last one isn't really a cost savings tip; more of an annoyance issue.
Why shouldn't I use my oem headlights? I'm on a bit of a tight budget so I don't think I will be able to purchase another set of headlights. I am in a group buy for the exact kit used in this thread.
* Registered users of the site do not see these ads.
kvo01 is offline   Reply With Quote