View Single Post
Old 04-02-2013, 01:13 PM   #7814
lunnstoppable
Scooby Newbie
 
Member#: 337488
Join Date: Nov 2012
Chapter/Region: South East
Location: Augusta, GA
Vehicle:
2013 STI Hatch
Bite Me Brock SWP

Default

Quote:
Originally Posted by CASHxMONEYxMIKE View Post

How hard was it to install the risers? I'm most likely ordering those next. Did you have to drill into your wing? And is it possible to adjust it a little lower so from the rear view the wing doesn't look so high up??
It was fairly easy and yes but only a tiny. bit. I have two bits of advice... 1. In the instructions in bold it says that on the MY11s and up there may be locktite on the inner two spoiler bolts... it is not a maybe... use wd-40 on those bolts or you'll break one like I did.

2. As far as the drilling its two small holes where two push clips were for self tapping sheet metal screws.

And yes they include spacers I used 3 out of 4 for the height it can be about .5 inches lower
* Registered users of the site do not see these ads.
lunnstoppable is offline   Reply With Quote