View Single Post
Old 04-02-2013, 08:22 PM   #7
ZURCALED12
Scooby Newbie
 
Member#: 309754
Join Date: Feb 2012
Chapter/Region: Tri-State
Location: Brewster, NY
Vehicle:
2012 Impreza Sport L
Ice Silver Metallic

Talking easy install , some wiring of the relay and you are done.

Quote:
Originally Posted by danstheman7 View Post
Holy crapola, insanely bright, nice job! Surprisingly cheap, install doesn't look fun though. How bad was the back install?
Not too bad, just got to put the car on ramps (I am a big guy) so it was easier for me and there are pre-drilled holes behind the bumper, just pop the rubber grommet out and push the wiring harness through, the mounting of the light is as easy as changing a bulb, pop out the cover/cap, slide the new light housing in and slip on the C nuts and bolt and that parts is done.


Pre-drilled hole behind grommet/cap.


This is the other side of the wheel well, behind the bumper cover, and no you do not have to remove the bumper cover either.


This is the rubber grommet that comes with the harness, you are going push it through the hole where you removed the other grommet/cap from.

* Registered users of the site do not see these ads.

Last edited by ZURCALED12; 04-02-2013 at 11:26 PM.
ZURCALED12 is offline   Reply With Quote