View Single Post
Old 04-08-2013, 11:22 PM   #89
Kean
Scooby Guru
 
Member#: 25187
Join Date: Sep 2002
Location: So. CA
Vehicle:
'08 Foz Prem TGM
'10 Challenger R/T Blk

Default

Quote:
Originally Posted by kabz View Post

This. Is what I need to get around to.

No one panic, the seat is tethered to the lower rings and tightened snug, but I haven't yet hooked up the middle tethers. I guess these should tend to stop the seat rotating downwards in a crash.

We actually have the Cosco seats, one baby and one toddler seat, and they have been good, are relatively cheap, and have good safety ratings.
Always check your owners manual for the proper anchor points. In my case I quickly discovered the '08 Forester only recommends the passenger or drivers side rear positions. .....I was wrong. There are only two pairs of latch points at those positions. If there was a center latch position there would be an additional pair of anchor points (a total of 6). My Challenger has 6 so I am able to install the car seat in the middle as designed.
* Registered users of the site do not see these ads.
Kean is offline   Reply With Quote