View Single Post
Old 04-09-2013, 11:39 AM   #3
ohemgeeitsNiko
Scooby Specialist
 
Member#: 239620
Join Date: Feb 2010
Chapter/Region: Tri-State
Location: Flushing, NY
Vehicle:
2003 WRX Wagon
Aspen White

Default

Quote:
Originally Posted by quazimoto View Post
1. Either there is a bent pin in the OBDII port or a pin has gotten pushed back out of the connector. It happens.
2. Romraider cannot delete codes from the DTC section on the 16 bit ECU. Disabling from here just stops the CEL from coming on with the DTC. The DTC is still active though. You physically have to go into the hex file and change values. The DTC "fixes" in the OBDII section are just that.
no luck on the connector, all the pins are straight and sitting all the way in properly.

ALSO, I know that the OBDII port is definitely getting power because when I plug in my Tactrix cable, everything lights up just fine.

and I tried to disable this evap system CEL the same way that I did with my rear o2 sensor code, but this one just wouldn't go away, my tuner took a crack at it too and he couldn't get it to work either. so you're saying that to disable this CEL is different then what the o2 sensor was? i'm aware that the DTC's still show up but I've disabled all the DTC's that LearningView is showing me. I'm just trying to get the CEL to disappear so I can finally have a legal inspection.
* Registered users of the site do not see these ads.
ohemgeeitsNiko is offline   Reply With Quote