View Single Post
Old 04-11-2013, 04:14 PM   #1
jadawgis732
Scooby Newbie
 
Member#: 208409
Join Date: Apr 2009
Chapter/Region: Tri-State
Location: NJ
Vehicle:
2012 WRX Sedan
WRB

Default Clutch Engagement Sensor Adjustment Help

So, I'm trying to install a clutch stopper like the one pictured here. I got the stopper installed with a lot of difficulty (there is hardly any room down there) but now the car won't start. This is because I need to adjust the clutch engagement sensor to match the new travel of the clutch. That is so much easier said than done.

Here is a picture from the thread I referenced.



Don't be fooled by the apparent ease of access. That picture is taken with a camera shooting up from the floor mat, and using a wider than normal angle. The way I see it, if I'm with my back on the floor, suspended like a torture rack (feet on the ground outside, small of the back on the door sill) well, everything is much tighter. Has anyone done this before or have any advice on how this is done? Thanks.
* Registered users of the site do not see these ads.
jadawgis732 is offline   Reply With Quote