View Single Post
Old 04-13-2013, 07:41 PM   #2615
bettner12
Scooby Newbie
 
Member#: 56179
Join Date: Feb 2004
Chapter/Region: MAIC
Location: Beaver Falls, PA
Vehicle:
2005 Legacy GT
BSM

Default

Quote:
Originally Posted by baseballdbk1 View Post

My setup is the same way with pulling no vacuum and works just fine!
Works just fine? Or doesn't suck? Sure it catches oil, but what else is it doing for you? There are way more reasons to pull vacuum on a crankcase than just to catch the air/oil/water vapors. I know a total loss catch can works okay, but that's not what I'm after with a good PCV system.

IMO your build would benefit from a vacuum pump more than most other motor mods you could do at this point. It's usually good for ~5% power gain.
* Registered users of the site do not see these ads.
bettner12 is online now   Reply With Quote