View Single Post
Old 04-20-2013, 01:55 PM   #15
Hondaslayer
Purified Dick
Moderator
 
Member#: 4562
Join Date: Feb 2001
Chapter/Region: NWIC
Location: Auburn, WA
Vehicle:
1995 Legacy LSi
1998 Forester, lifted.

Default

Looking at the original post more, I think your only "problem" codes are the P0336 and maybe the P1507 (P1507 could be a result of the fail to start).

In addition to the crank sensor, have you checked the cam position sensor as well? The ECM needs to see good signal from cam and crank to allow the engine to fire.

As cowboy_rob said the cam and crank sensor both are prone to electrical interference (note the special loom on those wires which acts as a faraday cage) If you cut either of those wires you may need to shield them.
* Registered users of the site do not see these ads.
Hondaslayer is offline   Reply With Quote