View Single Post
Old 04-25-2013, 01:35 PM   #50
S206DGM
Scooby Newbie
 
Member#: 339537
Join Date: Dec 2012
Default

Quote:
Originally Posted by DP2 View Post
The day following my PW install, the TB hose clamp slipped and was no longer holding the hose on. It was a bit scary when it happened.

So I pulled the IC and all hoses/clamps off. Starting with the IC to TB hose, I made sure there was a clear area at the TB connection point (moved some of lines out of the way just above the TB connection). I applied some hair spray to the hose, and worked until I was confident that the TB clamp was 100% secure.

Once that was done, I reinstalled the PW finishing with hose & clamps at the turbo inlet side. No issues since.
Did you use the hair spray on the inside of the tubing?
* Registered users of the site do not see these ads.
S206DGM is offline   Reply With Quote