View Single Post
Old 04-27-2013, 03:07 PM   #140
Raidenking
Scooby Newbie
 
Member#: 350606
Join Date: Mar 2013
Location: FL
Vehicle:
2012 WRX
Black

Default

Finally installed mine. I was able to wrap and place the OEM heat shield back on without issue.

Biggest problem was the ratcheting wrench I dropped, slid right to the middle of the engine bay out of sight. good thing I had another. Took me a quick drive and some time up on rhino ramps until I pulled down the cowling off the bottom and finally found it. Getting that thing out was a moment of joy.

I found the only extra bolt I needed to take off was for the power steering bracket. Without pushing that out of the way I'd have never gotten to the two bottom bolts on the heat shield.
* Registered users of the site do not see these ads.

Last edited by Raidenking; 04-27-2013 at 04:42 PM.
Raidenking is offline   Reply With Quote