View Single Post
Old 05-28-2003, 02:57 PM   #1
quasi888
Scooby Newbie
 
Member#: 25213
Join Date: Sep 2002
Location: South San Francisco, CA
Vehicle:
2003 WRX (Sonic)
2003 Honda CBR600RR (Red)

Default Subiegal WRX Single Gauge Pod install?

Hey folks -

If you have one of those WRX single gauge pods from subiegal.com (the one that fits in the corner where the A-pillar meets the dash), I was wondering how your are routing the wires/hoses.

I've got an Autometer mechanical boost gauge and I'm using 1/4" (O.D.) rubber hose. I can't see how I could route the hose to that corner location without it getting pinched between the dash/trim panels.

I haven't purchased this pod (yet), as I would hate to cut/drill into my dash....

Any help would be appreciated

Thanks

Dave
* Registered users of the site do not see these ads.
quasi888 is offline   Reply With Quote