View Single Post
Old 05-09-2013, 10:46 AM   #2855
needfx
Scooby Newbie
 
Member#: 345884
Join Date: Feb 2013
Default

[quote=Justin V;39685074]I had my motor out last week and did a few custom things to it.

20G went on as well as a 3" hard inlet so I had to work with the fuel lines, I just got rid of the metal lines under the manifold and ran rubber hoses. I pretty much just followed APS's instructions. I had the harness out too so I did the following,

Engine wiring harness, got rid of the uneeded plugs, air pump delete on my 07, 2x TGV plugs per side, and the air check valve that runs from the pcv to the turbo inlet. Also wrapped the gray part in black now.

I tried to do a wire tuck but Geez there is no room under there.



This is what came out.


Also deleted the oil heat exchanger to fit my EL headers on my 07 wrx.
Pulled the nipple from the waterpump and tapped it for a 1/4 npt plug, I guess next go round I'll just order a 08 wrx pump.


Also order the OEM plug for Legacies and what not without the heat exchanger and removed the nipple by the oil filter.



NEXT UP: temp switch on the I/C to controller the sprayer.
Isnt that a downgrade to remove the oil cooler?
* Registered users of the site do not see these ads.
needfx is offline   Reply With Quote