View Single Post
Old 05-30-2003, 01:58 PM   #5
Scooby Specialist
Member#: 33007
Join Date: Feb 2003
Chapter/Region: NWIC
Location: PDX, OR
2k4 STi <gone..>
96 XJ 4wd


Originally posted by Tobey

i did the same. i also actually drilled holes and fastened the pod to the pillar to secure it in the corner. i could not mount it without doing so, it didn't look right. after i did this it looked great.
had the similar gauge pod's quite good, but then it started to rattle after a while, so i just changed the gauge pod itself and got the carbon fiber autometer gauge cup.

i just put a black wire loom for the wires and hose. and personally like it much more. the gauge cup is fastened by double sided tape. i also had the option of drilling a hole and fastening it on the a-pillar, but decided against it, in case i get a 2-3 a-pillar gauge pod in the future.
* Registered users of the site do not see these ads.
pj_cab is offline   Reply With Quote