View Single Post
Old 07-09-2013, 01:56 PM   #13
jaboyd
Scooby Specialist
 
Member#: 247304
Join Date: May 2010
Chapter/Region: South East
Location: Knoxville, TN
Vehicle:
2011 STI
WR Blue

Default

Front"s look to have an extreme angle...Perrine bar might be a little shorter than the WL units..had a set of Cusco bars with the same issue. Can you shim the bottom (washer or spacer) so that they have less extreme angle?

The rear's appear to be mounted on the outboard side of the lower mounting bracket. Can you reverse them and mount on the inside?

Note: they all need to be torqued down quite a bit.
* Registered users of the site do not see these ads.
jaboyd is offline   Reply With Quote