View Single Post
Old 08-08-2013, 01:04 PM   #1403
Mechie3
Scooby Guru
 
Member#: 120152
Join Date: Jul 2006
Chapter/Region: MWSOC
Location: Indy
Default

Quote:
Originally Posted by AKGC8 View Post
What's track width is the 818 designed for, wagon, sedan?
Quote:
Originally Posted by AKGC8 View Post
there are two different mounting holes for the lower control arms, spaced slightly apart. So I'm guessing it's been designed to use either wagon or sedan control arms.
Correct. For upper suspension pieces there are also two holes, 1 for S ride height and 1 for R ride height.

Quote:
Originally Posted by Snowphun View Post
The kit apparently comes with new axles.
Axles are for the rear. It's not a complete CV assembly. You take the new axle shaft (just the steel rod more or less) and put the original front inner CV on one end and the original rear outer CV on the other to allow the rear hubs to be driven from the front output shats of the transmission.
* Registered users of the site do not see these ads.
Mechie3 is offline   Reply With Quote