View Single Post
Old 10-09-2013, 11:57 AM   #1
Spyderc85
Scooby Newbie
 
Member#: 367427
Join Date: Sep 2013
Chapter/Region: NESIC
Location: Peoples Republic of MASS
Vehicle:
2005 WRX Wagon

Default Would this Drivetrain Setup be sufficient?

TYPE STI CLOSE RATIO GEAR SET
http://www.rallispec.com/gea_syn_rst1141.html

This car is my daily driver atleast for the next 4 years

I have looked around and decided that with the exception of exhaust components i dont want to really start modifying my car until i get the drivetrain done. I have an 05 wrx wagon, my ultimate power goal is around 300 WHP.

My question is, would this gearset be good enough for my plans for the car or am i risking failure with 300 WHP. Thanks you threads in this forum i know to stay with a stock clutch with a stock Tranny, but if i switch to this gearset, can i upgrade the flywheel and clutch without risking the Tranny?

As far as other drive train components go, Im also thinking of going with

An Sti 5MT short shifter assembly
a 4.44 front and rear final drive set
as well as new Front, Center, and Rear LSD. (or would this be overkill for what i want to do)

And finally a new transfer gear 1:1

Thank You
* Registered users of the site do not see these ads.
Spyderc85 is offline   Reply With Quote