View Single Post
Old 06-29-2003, 02:40 PM   #8
Unsung Boxer
Scooby Specialist
Member#: 37196
Join Date: May 2003
Location: WA state

I had the machinist do it based on wayne's description.

THeoretically there should be even pressure by the head onto the block if torqued properly, thus the oring should seat no matter how close are far from the stud.

At any rate, im sure its fine, im really not worried about it.

BTW, hurry up on those pipes
* Registered users of the site do not see these ads.
Unsung Boxer is offline   Reply With Quote