View Single Post
Old 06-20-2014, 10:29 PM   #476
2Fast4U1DAY
Scooby Specialist
 
Member#: 250152
Join Date: Jun 2010
Chapter/Region: MAIC
Location: Pennsylvania
Vehicle:
2006 WRX Limited
OBP

Default

Quote:
Originally Posted by BeastianSTI View Post
OK guys, one of the local builders suggested that the block wasn't machined to the right specifications. He also said that he has had to send blocks back to the machine shop many times because they were incorrectly cut.

I just measured all of the bores, and with my Fowler dial bore gauge, (.0005 accuracy?) each of the cylinder PTW clearances appear to measure .0020-.0022. Could measuring without a torque plate / the cases torqued together cause such an inaccuracy, or do you think it could be incorrectly cut?
If it was machined with tq plates, then you have to measure with said tq plates or your readings will be off from that of the machinists. That said it doesnt mean that it has the right PTW even if you used the plates to measure your bores

However you had bearing issues so the PTW would be the least of your worries ATM
* Registered users of the site do not see these ads.

Last edited by 2Fast4U1DAY; 06-20-2014 at 10:36 PM.
2Fast4U1DAY is offline   Reply With Quote