View Single Post
Old 06-20-2014, 11:24 PM   #477
BeastianSTI
Scooby Specialist
 
Member#: 310506
Join Date: Feb 2012
Chapter/Region: South East
Location: Florida
Vehicle:
2005 WRX STi
Silver, Sexy 'n Raspy

Default

Quote:
Originally Posted by 2Fast4U1DAY View Post

If it was machined with tq plates, then you have to measure with said tq plates or your readings will be off from that of the machinists. That said it doesnt mean that it has the right PTW even if you used the plates to measure your bores

However you had bearing issues so the PTW would be the least of your worries ATM
I've already cleaned up the mess from da bearings. New oil pan, pump, cleaned avcs lines, oil galleries, cleaned block and heads.. turbo, etc.

I want to make sure my block isn't going to need a rebuild in 5k lol
* Registered users of the site do not see these ads.
BeastianSTI is offline   Reply With Quote