View Single Post
Old 07-11-2003, 12:57 PM   #5
Scooby Newbie
Member#: 28830
Join Date: Nov 2002
Chapter/Region: NESIC
Location: N. E. VT
6807 RIP Colin McRae
97 OBW Limited


GTBGUY- good idea..dont know if too many of those are banging around...but its a good thought.

the motor is already disassembled, and the heads are off...block is not split yet, thats coming in the next few weeks...
the rings were smoked in the engine, it smoked quite alot so i m looking for pisitons and rings etc...too

i dont know what i want to do to this motor yet, it was a spare lying around and i figured its perferct to learn on. i was thinking a 2.5 crank....(possible, right?) sending the heads out...any ideas on whos the best for that?
im still in the very early stages of rebuilding so any suggestions are definatly appreciated!

i would like to go mediocre high performance on this engine, but its gonna take awhile to save up for each addition to it. so its a nice sunday afternoons' project
* Registered users of the site do not see these ads.
stant093@ is offline   Reply With Quote